1/21/2024 0 Comments Pluraleyes 4 crashes after syncIf you have the time, shoot a 3-minute test where they have a good look at the TC slate for ten seconds and a clap, then roll for a few minutes, then clap at the end. More recent software updates have pretty much eliminated this, but not all cameras are running current software I have seen the Red Ones lose sync on reboot, drive changes, or power cycles. Will ask post the more specific questions above tomorrow. Post said they will charge extra for manual sync and I'd better fix it. I've ordered a 5pin lemo to bnc from cam retal house but it won't be in (if they have one ) until afternoon. The Deneke is feeding cam constantly via the the red sync cable from trew (xlr to 5 pin lemo, into xlr to bnc adaptor plugged to Deneke) All info I have is two takes in afternoon were sync everything else there was "a gap". We have the chain link on cam and post informs that we are not sync. My recorder is a fostex pd-6 (purchased recently from Jay Hartigan) running as master TC 23.98 which I jam twice a day to Deneke sb2a hanging on cam. This link gives more discussion that this is "normal" Shooting image on red one mx at 23.98 (it says 24fps on the monitor but they assure me it's a 24 time base and actually 23.98. Okay so this shoot had been a great learning experience and a whopper on the nerves! Only day 2 ! I can't wait to learn more everyday !!
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |